[1loudLX]

Anyone know how to get the radio to tune in smaller steps in the 430+ bands? Say if I wanted to listen to 480.8125 It only lets me pickup 480.800 or 480.825. Is there a radio setting to change that?

[alia176]

I don't have that radio but in the mean time, can't you just type in that freq using the mic?

[1loudLX]

ima idiot, I forgot you could do that. Thanks!

[Kofoed]

manual says you can tune down to 100kHz steps

[rusty_tlc]

RTM (Read The Manual)

1) Tuning Dial
Rotating the DIAL knob allows tuning in the pre-programmed steps established for the VFO
frequency. Clockwise rotation of the DIAL knob causes the FT-7800R to be tuned toward a
higher frequency, while counter-clockwise rotation will
lower the operating frequency.
Press the [MHz(PRI)] key momentarily, then rotate the
DIAL knob, to change the frequency steps to 1 MHz
per step. This feature is extremely useful for making
rapid frequency excursions over the wide tuning range
of the FT-7800R.

I assume you can adjust the steps down in the same manner.

[1loudLX]

O but I knew that, Which wasn't my problem.