 |
|
11-11-04, 07:23 AM
|
#1 |
|
Admin
|
rear axle shafts...
Working on building a custom rear end, planning to run a Cruiser center diff but use minitruck rear shafts. I have a few 85-older rear housings to use as doners (and lots of shafts) but am considering setting up the rear end width to allow use of 86-newer rear chromo shafts....
so the question...is length the ONLY difference between the 85-older rear shafts and the 86-newer rear shafts? Same outer bearings, mounting system, etc??? __________________ Brian 'woody' Swearingen Lead Driver, Toyota Trail Team (Central) '07 FJ Cruiser...Revtek, 285 BFG-AT's, ARB/Warn, BudBuilts, 93k miles... '74 FJ40 'The Raisin'...TBI350, mVB 700r, 4:1 32-spline D300, SOA/ellip 4-link, RoundEyes, 8274-50/WinchLine, 30-Longs, 37" PBR's/TR's... '95 HZJ75...1HZ, H55F, mine bed, BFG-MT's... '96 FZJ80 'Gretchen'...OME, E-loks, 285 FCII's, ARB/T-Max10k/WinchLine'd, MetalTech'd, 4x4Lab'd, IPOR'd, Slee'd, UltAir'd, INTI'd... '03 Chevy 2500HD Dmax, Diamond Eye 4", Diablosport, Bose, 285 Nitto TG's, B&W... '08 ABU 14,000# 32' gooseneck car hauler... '?? buggy ??...5.3 Chev, 700r, Atlas, axles?, SAW's, 7075/QA-1's...design phase 1... Glock 17C - Kahr CW9 - Sig Mosquito - Davis D-32 - Remington 7600 - Marlin 30AS - Ruger 10/22 |
|
|
woody |
| Bookmarks |
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
All times are GMT -6. The time now is 04:37 AM.
