[traillme]

There are many threads that focus on troubleshooting issues with the 2F. What are some recommendations for troubleshooting SBC issues?

A little 'd up so please excuse the grammer.

[D'Animal]

Post in Other Vehicle Tech section.

A lot of guys on this board are SBC guys. Quit a few are running them in thier FJ's.


Here is the link.


http://forum.ih8mud.com/forumdisplay...ysprune=&f=103

[brokenparts]

Whatcha got goin?

[justin85-60]

I may be going chevy too. Any estimates on total cost without labor? What sould I be looking for and looking out for when buying parts. Is there a parts list and how to out there?

[traillme]

There are quite a few things going on

• Inconsistent Idling
• Stalling at stops
• Jerking at low speed

Fuel Filter , EGR and PVC are all on my replace list. The major prblem is that when the 91 TBI was swapped in only the check engine light was installed to pass Cali emissions. The crappy ECM scanner I have requires the other engine light so that it can blink codes. What do I have to do/or what resouces are available to learn how to run the second light to the 60 dash?

I really appreciate any help.

[traillme]

bump

[traillme]

Anybody have a picture or description of the location of the EGR valve on an early 90's sbc?

THANK YOU!!

[cody c]

if you could find out where the other light was connected to you might be able to wire a bulb in to trouble shoot,

Justin85-60, there are lots on here who have done this swap, i believe most get the adaptor from marks to the transmission, and get a 350, i believe TBI is what most go with, but many like EFI for mileage and power although it makes things more complex. There will be parts than need to be fabricated with this sort of swap, for example: exhaust, motor mounts, air intake adapted, etc. etc.

Try searching around and you should find more info, there should be some good stuff here for ya.