| I fabricated the last two body mounts, for the floor under the front seats, installed them, & welded them to the rockers I built a few weeks ago. I welded in the last supports for the floor, & cut the steel for my floor pans. Tomorrow after work I hope to get the floor pans welded in and a coat of primer on.
Now, with the front body panels cleaned up and ready for paint, and the front floors, 4 body mounts & cross member now re-placed, I have only to clean up the rear floor and fender wells & get them ready for paint, then re-skin the rear quarters, re-install the heater, seats, gas tank, etc., and she is done.
Can't wait to get her rolling again. I haven't driven her in about 5 years. I only hope that I get to go wheelin' before the snow fits.
__________________
1976 FJ40, 350 Chevy sb, Ranger II OD, onboard air, 4" lift
1984 BJ60, 3B diesel, stock(Canadian vehicle)
2009 VW GTI, 200hp 2.0L turbo, 6 speed manual
|