Quote:
Originally Posted by dmaddox
On the new ignitor we have:
1. Two eyelets going up to the coil, they were disconnected but are:
a) Yellow
b) Two black
2. We then have a long plug that has two wires red and white that plugs into the distributor (easy enough).
3. Then we have two Green female plugs.
In plug A) Single black wire.
In plug B) Tan (faded brown maybe) and Yellow (the yellow in 1/a I spoke of).
Any thoughts on this?
Thanks - Dallas
|
Your color codes for the wires don't jive with the Toyota schematic. Some have an insulation sleeve over them, so pull it back and take a peek at the color code.
This picture from an earlier thread on a '78 ignitor may help, but it is wired incorrectly and the correct connections are indicated in writing. The hot wire for the ignitor (black/yellow stripe) also connects to the big black/yellow ignition wire at the ballast resistor, but you can't see it in the picture.
