A couple of shots of my puttering with the roll cage. This is a 1/4" plate with counter sunk bolts on the outside and another 1/4" plate of the same shape on the inside with nuts welded to it. Eventually the outer plate will be the anchor point for the A pillar tube and the inner one will mount the tube that runs down to the floor. The drivers side mount required the relocation of the headlight switch - I'll likely put it where the choke is as I won't need to choke the 3B
. The passenger side required a trimming of the glove box wall which I will finish out and clean up while doing the tub bodywork. The large holes are for the side window defrost vents which I had to miss. Also, I will be running a tube across the dash to connect the two A pillars. This will require removing the dash pad permanently and replacing it with my own custom dash pad that opens up for storage.
