Help with a clutch slave cylinder

Seth_O · 04-06-07, 10:52 PM

After much waiting, sweating and grunting I finally finished a 2f install in my '68 FJ40. Unfortunately I started the tear-down ~9mos ago, and cannot now remember how my clutch slave cylinder installed on the bell housing

. It kills me to listen to my girl rumble contentedly for the first time in so long when I can't drive her!

Can someone post a picture of their slave cylinder installed on a e-74 FJ40 w/3spd tranny? Just can't seem to get it exactly right.

Much thanks for any help

grant5127 · 04-08-07, 06:29 AM

the parts in the pic are bolted to the L R MT MTBRKT........

Seth_O · 04-10-07, 02:56 PM

Tks mate - found that picture in my SOR catalogue, was having a hard time deciphering what that back bracket was, now have it figured out and am happily out wheeling

74fjsemistock · 04-10-07, 05:18 PM

So much good on this site.

TOR25 · 05-09-07, 02:25 PM

I have all those parts.. but was unable to figure where that back bracket mounted. In my situation it seems impossible for that bracket to go towards the rear of the vehicle.