09-07-08, 03:53 PM
|
#1 (permalink)
|
|
250+ Club
Join Date: Dec 2003
Location: Ft Meade or Roanoke
Posts: 877
|
oil pan and gasket
well i replaced the oil pan gasket once and it leaked pretty bad on the corners where the bearing caps are. it has been a few years since i replaced a op gakset and that was on my 74 F motor and i didnt' have any problems with that. this time i didn't pay that much attiention to it when i put it on but only to the bolt holes to make sure they linged up. I bought a new gasket and compaired it to the one i put on and its the same and then i fit it on the oil pan and in the corners it dont quite fit like i think it should. its sticks up in the corners almost 1/2" Is this normal?
__________________
74 FJ40 Mustard Yellow 2.5" procomp springs, rancho 5000s, sr5 seats, 32x11.50 BFG A/Ts awaiting 2f, h55f with split case to be installed.
87 FJ60 White 3"ome heavy,4plus flipkit, 33x10.50 BFG A/Ts on Eagle 589s, mwalls54 f+r bumpers with rock sliders/steps and rear 1/4 protection, mean green, H55f, hella h4 and 4000s, LED cargo lights. warn 9500ti, a lot of non usa parts on the dash.
WV Mountaineer Cruisers TLCA Delegate
Tornado Alley Cruisers
|
|
|