Quote:
|
Found my FSM : 43 ft-lbs or 59 Nm They just want you to seat the bearings, fully, so when you pretty-much finger-tighten the nut, there's no hidden play...
|
No, that is not right.
First you torque the adjusting nut to spec to seat the bearings, then loosen the nut and then retighten to remove all movement at the bearing, then add a small amount of preload, then continue to TIGHTEN the nut untill one of the marks on the nut lines with one of the marks on the stub.
Install and tighten the two screws in the holes which are located at 90 degrees to the marks that you have aligned.
Never assemble these full floaters with finger tight setting at the adjusting nut.