Quote:
Originally Posted by Z()LTAN
hmm that pinion angle is  |
the axle and frame in pic are at anticipated ride height. the axle pinion angle shown is the same as the tcase output flange which is only 3 degrees from verticle. so the pinion flange and the tcase flange are both angled like this \ 3 degrees-so the pinion flange is angled up 3 degrees. I hope this is correct. If I get vibrations I will need to either get a different axle that is offset to the pass side or try pointing the pinion at the tcase.
__________________
97lx450
4" slee/j's, sliders, bumpers, 3" exhaust, custom turbo, HG pm/Valve job/seals, sweet custom skid plate, Sleeoffroad parts, Buys oe parts from Cruiser Dan
used to have 37" swampers..
1 tons and 42's pending.....
Budget Blown
98 100 series. rear locker.
2008 6.7L dodge 2500 quad cab
Last edited by Dusty; 05-28-08 at 11:11 AM.
|