Quote:
Originally Posted by FZJ80ismybaby
with the spring perches, did you just cut them off, and the axles are just free floating?
|
Jason cut off the old spring perches and ground it down to the a clean finish, then placed the new ones on top. The front axle came cut and turned with spring perches attached I believe. It's a typical Spring over axle conversion, just took the axle from sitting on top of the leafs and set it up so that the leafs sit on the axle gaining about 5-8 inches of lift, case dependent. I'm not sure what you meant, are you asking if they are free floating axles? If that is what you are asking, then no. If the rear was a free floating axle then it would have helped with the gears. In order to get the 4:88s in, the gears had to be ground a little to fit in the pin. A problem that isn't on a free floating axle. Shocks are going to be configured and installed soon. It's going to be a sweet ride!!!! I can't wait.