Quote:
Originally Posted by dgangle
I would tie in these two points on each side. Looks nice. What type of tube and bender did you use. Cost?
|
It was either 14 or 16 gauge. Don't remember. About $35 for 20ft. I probably have $100 in the steel.
The bender is just a manual hand bender like this:
Model 3 Manual or Hydraulic Tubing Bender at Van Sant Enterprises, Inc.
__________________
Quote:
Originally Posted by wob
Roll Tide!
|
1974 FJ40 FI vortec 350, H42/Orion 4:1, 4" lift, 35x15.50 SXs on MRW beadlocks, lock-rited f/r, Saginaw ps, etc, etc.
1994 FZJ80 with lockers and 285 revos.
|