|
The tongue and groove allws the deck to flex, if it didn't it would just crack apart - pretty tough stuff to - might try them for bike ramps.
The exhaust i made it so I can remove sections as I am still not done with the truck, I will add a rear tank eventualy so I will need to reroute the exhaust. I was also off slightly on one section and I get some frame rattle on start up - so I have to cut and reweld it. Overall I like the way it runs and sounds as quiet as the stock muffler but with no obstructions - you can see right throught the aeoturbine muffler. I would have went straight pipe right out but I have to leave my driveway at 6am to go to work and I like my neighbours.
As far as clearance goes I think I have 12 inches from the 33's to the deck, I think I have 7 from the bump to the axle housing - will have to measure that.
Thanks for the comments.
Louis
|