[WristPin]

use two boards for this, cut them both the same, but one for NF, one for NC. personally i would choose somthing nice, like black walnut.

use your combo square to scribe horizontal lines on it, drill holes in the right spots, and put bolts through the wood. with each bolt corresponding to the die. secure the bolts with a nut. i would use a short bolt, so you only need to secure the die with a few turns.

then hang it on your wall right above your vise, where you do all of the threading.

i think it would look equally nice to do the same with the dies. with the exception of bolts. just drill holes.