[5280Hawk]

Got back into my project last night since im back from Cali.

Disney's California Adventure has an Old Rusted FJ45 sitting near the rafting ride. I took this photo while we waited in line.



pretty cool.

Anyway, I was looking over my back doors to be sure they were ready for paint and realized that the passenger door- (where there had been some previous body work done) was not straight along the bottom. I took a straight edge along it and compared it to the driver door and the body filler was a good 2-3 mm indented in the center, and the area was probably 8" diameter . I wish i had the funds to just get rid of the door and get a straight one, but nope, it got more bondo. So for all you purists out there that can't stand a little filler - . I used my biggest block sander, and got it flat again. Im much happier with the results, but still haven't got any paint down. I have some more sanding, then masking to do before this round of paint goes on.