The guys have been working hard on this 4runner/buggy this week.
Got the floor/slider bracing measured, cut and tacked in.
Bent the Main hoops and tacked those in, bent the drive train hump tubing and tacked that in, and got the a-pillars bent and tacked in.
We have a full cab now!
Not to mention the motor is mounted.
This thing is coming along great, and its impressive to watch the guys in back work on this type of custom fab.
And the pictures:
here you can see the 2 main hoops in along with the floor hump
the hump itself
the chassis again
the a-pillars are added here, as is the motor
(ignore the bar sitting across the floor that you see)
here's the sliders, notice that the back goes down and the front goes up. We did this to accommodate fitting the large tires in there, with the axles location being so close and not causing clearance issues
the motor/floor hump
a rear view
