[mrqtipp]

I mounted the the engine and drive train as high into the body as possible and as a result I had to fabricate a new radiator mounting straps that lift the raditor 3inches in order to center the raditor to the fan.

Used two pieces of channel mounted to a stud that attaches to the stock placement of the cross member.

I ran two verticall rods which attache to another piece of channel on the top of the radiator. The vertical rods then tighten with nuts.

Fabricated a fan shroud that attaches to the bottom pieces of channel and to the top of the channel.

The radiator then attches to the firewall with two addjustable heim joints (rods).