Looks like quite a novel solution. Just a couple of questions:
What does the red LED do?
Where did you get your LED lights; I really like those.
Did you use switched power for everything or just for the switch and LEDs and then unswitched power for the locker? Obviously the diagram shows a single power source and I assume that if it was unswitched that the relays and the LEDs would always see power. Lastly, where did you source the power?
Apologies for all the questions!
I have pretty much decided to put 2 new TRD elockers in this summer. I want to go to 4.56 ratios and I've had no luck sourcing these used. If you buy a used one with a different ratio then you have to spend $400 to $500 regearing and I can buy a new 4.56 for $940 delivered.
I also think I'm just going to use an FZJ80 rotating switch like Foxfab but I want to put a locked front and locked rear LED beside the switch. I like the way this switch works (and looks) in my 80 and my 100.
Now if I just pay Foxfab or KLF to build that circuit for me.....
Everyone's posts in this thread have been extremely helpful! Thanks!