Quote:
Originally Posted by zcruz
What are you running?
|
Not Toyota....
4.3 Atlas 32 spline outputs, 1350 High Angle driveshaft, Sunray fabricated rear axle housing, Hi9/ARB 35spline/300M CTM axle shafts..
and listen to this:
Quote:
Originally Posted by wngrog
ditch the 3 speed case. Do that WAY before you offset the D60. That would be wise.
Anything is an upgrade to a Toy 3 speed case.
Once you fix the shaft issue, your next problem lies there.
|
They are compounding issues. (your driveline failing and finding the next weak link)
If you really want the ability to run your junk hammer down, you are going to need to step up to quality components. Sell that doubler-case affair, and just get a quality transfer case based on a Dana 300. Find a Dana 300, rebuild it, install lower gears and upgraded front and rear output shafts, or get a STaK or an Atlas II.
An Orion HD would allow the 32 spline ouputs front and rear, and an offset rear output, but you will not get a front dig option with this. Once you use that, you will never want to go with anything else....
All it takes is Fun ticketsŪ
