Quote:
Originally Posted by Tennessee80
what is the best way to obtain either a tundra, taco, or 4runner shaft for the front of an 80, junkyard?
|
I assume your question is just meant to be all encompassing but remember the 4Runner shaft is for the
REAR. However, any of the shafts should run from $40-$80 depending on the junk yard. From my experience so far, it seems some of the u-joints at the slipe yoke ends tend to have a hard spot in them. If this is the case, I would recommend picking up a new NAPA u-joint for $18. The NAPA u-joints are made by GMB in Japan and carry a life time warranty. These are also the same joints Man-a-fre sells for slightly more money.