[5280Hawk]

I got some work done on the fenders and front valence over the weekend.

I finally pulled the passenger fender, It was pretty dang cold to be out there under the cruiser. but oh well,

Shot of the two fenders and valence - they don't look too bad from that angle

close up of valence before -


I basically sanded ALL of the paint off to get all the chips to go away,


Fenders before -


Close up of rusty areas by the wheel well -

I have one of the fenders almost ready for paint - you can see some of the bondo work in the photo -


I also used some JB Weld to fill the holes from the Snake Blinder - I still have to sand it down and see how it holds up.


I plan to finish up the rest of the body work and start rolling again in a few days.