Quote:
Originally Posted by locrwln1
I probably wouldn't use that van 60, check to make sure it's not a 61, they are set up for highway gears and take a little work to get everything to work right.
Also, yes you can do 35 spline shafts for 60's, very few have spindle bores big enough. The spindles have to be bored out, or other spindles welded on. The outside of the spindle is the same as Dana 70/14 bolt, its just the inside that needs to be made bigger, so that the bigger axle can fit in.
Yes, they do make 35 spline ARB's for 60's.
As far as centered rear axle, I would think that would put the driveshaft into too many angles. Of course the 80 axle is only off center a little bit. 
Jack |
thanks so a d70 spindle cant bolt on. I would hate to weld stuff like that. im sloppy but not that much
__________________
97lx450
4" slee/j's, sliders, bumpers, 3" exhaust, custom turbo, HG pm/Valve job/seals, sweet custom skid plate, Sleeoffroad parts, Buys oe parts from Cruiser Dan
used to have 37" swampers..
1 tons and 42's pending.....
Budget Blown
98 100 series. rear locker.
2008 6.7L dodge 2500 quad cab
|