No wiring diagrams that accurately replicate what I have to do so ALL of my work has been done by BRAILE and a dozen phone calls to Painless PErformance Harnesses for assistance with their "special" harnesses...
Here's the partial results. I should be done today, but it's iffy. I had to get a pair of relay's so I can wire teh single bulb tail lights to blink and brake at the same time...
The hardest part will be to wire this 6 wire turn signal harness into the 9 wire emergency flasher switch, while trying to tackle an uncharted 4 wire ignition switch to power everything at the correct time
(painless my arse!
)
It's looking good so far... Mechanicals are next. Getting it to run perfect with a GM carb is going to be fun... Then the steering knuckle rebuild... Etc....
