I am not sure what would of happened if I had rolled.
1. My stock roll bar would of crunched.
2. It would of poped threw the wheel wells.
The body is less then show condition. So I cut out the
offending area above to this.
To keep my patch even, I then welded in a strip on the lip.
Then to Top piece.
The other side was worse so I cut out more.
Above you can see my replacement piece I bent up, ready for
install.
Here is it welded in.
I should be able to tackle the drivers side kick panel on friday, and hope it comes out as good as the passengers side I did
last year. Below are pictures from that.
