OK boys, I finished the template for the rear floorboards. Here are some pics of what I did.
There is a bend in the floorboard where the line is in this pic. It's on the other side too. I estimated the bend to be about 3-5 degrees, but don't have any way to measure it. Can someone take a look at theirs and see if they agree or can measure it somehow?
Here is the bend...it goes right through the fist set of raised humps. This shows the angle pretty well:
These are pics of the "humps" and brackets underneath. Ehsan, you will need to see pics of these since there are holes in the floorboards for mounting the seatbelts. There are 2 brackets, one larger and one smaller. I marked their location on the template.
Humps:
Big Bracket:
Small Bracket:
Ehsan, as soon as I have some confirmation back from folks on these questions, I'll get this into the post to you ASAP.