[paranoid56]

Next up was the floor. I orderd a full sheet of 18ga (4x12 for 80bucks) i also had them shear 2 14"x4' long strips and 2 16"x4' this way i knew they were perfect

so i cut one to fit on the passerenger side and drivers side. then i finished up making the center bump. I had to do some notching on sides to make it fit perfect.


and the finish result. its not welded yet, and not fully done. but you get the idea. I havent figured out if i want to replace the whole floor yet either. the passenger side has been cut up my the PO, and the drivers side is sort of rusted. I guess it would just be as easy to make a full piece. damn, i wish i thought of this when i was out in the shop today